Avermedia EB1104 NET Especificaciones descargar pdf (Pagina 58)

1. Connect /Disconnect : Click to connect to

DVR1 server from a remote client. The button turns yellow when it is

connected to the network. The system will show the following Client

Connection Manager screen. Enter DVR1 server’s IP and password. Click

OK to connect to DVR1. To disconnect the connection, click

again.

When you connect to a DVR from a remote client via network, please

don’t connect your DVR and PC with an USB cable.

2. DVR State Control : Click to set DVR1 settings

when DVR1 is under viewing mode. You can see the DVR Record Mode

and Hard Disk Information on the upper-right corner. You can modify Video

Quality, Record Frame Rate, Alarm Out Time, Sensor Record Time,

Audio Record, Audio Mute, Recording Schedule, Input Channels,

Record Channels, DVR Time on DVR State Control dialog. For details,

check 4.5.1 Setting DVR Control from Remote Center. For details, check

4.5.1 Setting DVR Control from Remote Center.

3. DVR Information: The dual remote center shows system status of DVR1

server, including DVR server IP, Video Mode, Speed and Frame Rate.

4. 1-CH Display Mode : Click

, , and to enable cameras. Switch

between Camera1- Camera4. When you click a camera button, the button

turns yellow.

You can choose to enable or disable desired cameras. The screen will

show “Disable Camera” on the screen if you disable some cameras. When

you click , , and at the same time,

you will see the following camera sequence.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 68 69

Sin comentarios

Avermedia EB1104 NET Especificaciones Pagina 58