Avermedia EXR6004 Manual de usuario descargar pdf (Pagina 54)

- Start Recording

Record the video from the selected camera.

1. Next to the Start Recording check box, click

Detail.

2. In the Alarm Recording Setting dialog box,

select the camera to enable/disable video

recording. Enable All to select all cameras.

3. In the Frame Rate selection, select As Setting

to record the number of frames based on the

Recording Setting.

4. In the Start Record prior text box, mark and

set the number in second for the program to

begin recording after the alarm has been

trigger. The time range is 1~10 seconds.

5. In the Stop Record after text box, mark and set the number in second for the program to

continue recording after the alarm has ended. The time range is 1~999 seconds. If user doesn’t

mark and set the time, the alarm recording will continue recording until alarm is reset.

6. Click OK to accept the new settings and Cancel to exit without saving.

- Send to CMS (Central Management System)

Enable/disable the selected camera to send video to

CMS when the alarm is activated.

Next to the Send to CMS check box, click Detail. In the

CMS Setting, select the camera to enable/disable

sending the video to CMS. Enable All to select all

cameras. Then, click OK to accept the new settings and

Cancel to exit without saving.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 116 117

Sin comentarios

Avermedia EXR6004 Manual de usuario Pagina 54